Standard testing of photovoltaic modules for use in renewable energy education

Authors

  • David Agar University of Jyväskylä, Department of Chemistry, P.O. Box 35, FIN-40014 Jyväskylä, Finland.
  • Jouko Korppi-Tommola

DOI:

https://doi.org/10.31129/lumat.v3i5.1013

Abstract

A photovoltaic laboratory exercise has been devised and used in the educational curriculum of the Renewable Energy Programme at the University of Jyväskylä. The purpose of the experimental tasks is to give students of renewable energy a good understanding of standard testing procedures used in industry for characterising photovoltaic modules and to provide practical skills in sizing simple photovoltaic installations. Herein the experimental set-up, basic theory and measurement procedure are described. The experimental apparatus is simple to assemble and uses both standard laboratory equipment and recycled components. From the experimental results, the tested PV cell had a maximum efficiency of 1.4 %, a fill factor of 0.58 and an electrical power production of 300 mW at the maximum power point of operation under standard testing irradiance of 1000 W/m2. At this power output, the load resistance was 0.15 kΩ and module temperature was 25 ± 2ºC.A photovoltaic laboratory exercise has been devised and used in the educational curriculum of the Renewable Energy Programme at the University of Jyväskylä. The purpose of the experimental tasks is to give students of renewable energy a good understanding of standard testing procedures used in industry for characterising photovoltaic modules and to provide practical skills in sizing simple photovoltaic installations. Herein the experimental set-up, basic theory and measurement procedure are described. The experimental apparatus is simple to assemble and uses both standard laboratory equipment and recycled components. From the experimental results, the tested PV cell had a maximum efficiency of 1.4 %, a fill factor of 0.58 and an electrical power production of 300 mW at the maximum power point of operation under standard testing irradiance of 1000 W/m2. At this power output, the load resistance was 0.15 kΩ and module temperature was 25 ± 2ºC.

Downloads

Published

2015-09-30

How to Cite

Agar, D., & Korppi-Tommola, J. (2015). Standard testing of photovoltaic modules for use in renewable energy education. LUMAT: International Journal on Math, Science and Technology Education, 3(5), 693–701. https://doi.org/10.31129/lumat.v3i5.1013

Issue

Section

Articles